Pretemporada 2014

[iL Fenomeno]

Esos triángulos de suspensión.... Han llevado el reglamento al límite en la zona de escapes.

El reglamento dice que los triángulos de suspensión (wishbones) son legales siempre y cuando la sección vertical no sobrepasen los 5º de desfase respecto a la vertical...

"10.3 Suspension members :

10.3.1 With the exception of minimal local changes of section for the passage of hydraulic brake lines, electrical wiring and wheel tethers or the attachment of flexures, rod ends and spherical bearings, the cross-sections of each member of every suspension component, when taken normal to a straight line between the inner and outer attachment points, must :
a) Intersect the straight line between the inner and outer attachment points.
b) Have a major axis no greater than 100mm.
c) Have an aspect ratio no greater than 3.5:1.
d) Have no dimension which exceeds 100mm.
The major axis will be defined as the largest axis of symmetry of any such cross-section. The length of the intersection of this axis with the cross-section must not be less than 95% of the maximum dimension of the section.

10.3.2 Suspension members having shared attachment points will be considered by a virtual dissection into discrete members.

10.3.3 No major axis of a cross section of a suspension member, when assessed in accordance with Article 10.3.1, may subtend an angle greater than 5° to the reference plane when projected onto, and normal to, a vertical plane on the car centre line with the car set to the nominal design ride height."



Croquis de Scarbs....

Estas generando un beam wing nuevo....




Buena solución.